electronic cigarette
EdSylver® electronic cigarette provides to its users an artificial flavored smoke with or without nicotine.
A replaceable cartridge filled with an aromatic liquid is located at the casual filter location. The ingredients contained in the cartridge include nicotine (optional), artificial flavor of tobacco and glycerol.
During inhalation, the microprocessor enables a spray mixing the air inspired with the liquid contained in the cartridge. This mixture is cleared as steam which is inhaled by the user. Evaporation of glycerol allows an imitation of real smoke produced by a cigarette.
A diode light at the end of the cigarette mimics a true combustion. The device does not only imitate the look of a cigarette but also delivers the sprayed mixture at a temperature of 50-60 Celsius degrees which is comparable to that of a cigarette.
EdSylver® electronic cigarette is a healthy alternative to tobacco consumption. Because there is no combustion, it does not content any carcinogen such as tar. The only substance inhaled is nicotine which is involved in smoking addiction.
This product – such as other types of nicotine substitute - is not appropriate in young people, pregnant women, people with cardiovascular disease or people not used to smoke.
Upon receipt of your EdSylver Kit, we advise you to leave your battery charger for at least 10 hours in order to maximize the capacity. This will allow you to keep a good battery life of your battery much longer.
Do not use your e EdSylver with cigarette filter demonstration provides.
It does not contain liquid and its use can cause desiccation of the sprayer. Take a filter nine of the concentration of nicotine in your choice and insert it into the sprayer.
When the steam decreases, then you should replace the cartridge (or filter) that will be coming to the end of its lifetime.
The decrease of steam may also be due to a malfunction of your sprayer. It is then cleaned by blowing on the inside to the lead. This can occur after using a dozen cartridges. Indeed, impurities can not drag and thus obstruct the flow of air. The steam can thus be created.
Remember to change from time to time this sprayer. You can find this piece, which is an essential part of our electronic cigarette EdSylver in our online store at a reduced price.
If you encounter problems when using your electronic cigarette EdSylver, please contact us by email at: sav@edsylver.com.
We will reply as soon as possible.
1. Screw the battery on the spray.
2. Remove the inhaler at the other end to insert a new cartridge.
3. Insert the inhaler filled with nicotine that you find in the box "replacement cartridges."
When the light indicator decreases in light intensity, recharge the battery by using the battery charger located in the box. Complete charging is obtained in approximately 3 to 4 hours when the light indicator turns from red to green.
During inhalation, the electronic circuit switches on and the diode light at the end of the cigarette goes into ignition.
When inhalation is over, the electronic circuit switches on stand-by mode and the diode light at the end of the cigarette goes off.
Holding the cigarette in a horizontal fashion and not in a vertical fashion is recommended in order to avoid cartridge leaking and direct contact with mucous membranes.
When the LED indication of operation begins to subside, it is time to replace the battery.
A casual cigarette usually includes 14-16 puffs. Therefore after 14-16 inhalations with Edsylver® electronic cigarette, the smoker should stop using the electronic cigarette for at least 30 minutes before a new use.
- Do not connect the battery to metal.
- Keep batteries away from any heat source while loading
- Do not open or break batteries, do not throw them into fire.
- In the event of a leak coming from the battery and causing a liquid electrolyte contact with eyes or skin, do not rub. Rinse the affected area thoroughly with clean water and call your doctor or poison control centre.
- If during the load, the battery changes color, bends out, smells like burn or if any unusual event happens, immediately disconnect the electrical outlet and remove the battery charger using a dry piece of cloth in order to take a hold of it. Do not use it anymore.
- The shipper has been specially designed to recharge the lithium batteries of the electronic cigarette EdSylver ®. Do not use it mainly to load any other type of batteries at risk of seeing ignite or explode.
- During the first use of a battery, the duration of load should be at least 8 hours. The charges following last between 3 and 4 hours.
If the electronic cigarette is not used for a long period, remove the battery from the cigarette and charger. Store safely away from anything flammable in a cool dry place.
